Skip to main content

PMS 530-1

PMS 530-1

PMS 530-1

NWCG Standards for Aviation Risk Management, PMS 530

NWCG Aviation Risk Management Workbook, PMS 530-1

How to Use Workbook

IMPORTANT: How To Use Workbook

Submit Revision / Recommendation

Fixed Wing Risk Assessments

Helicopter Risk Assessments

Unmanned Aircraft Systems Risk Assessments

Other Risk Assessments

 

Hot Loading

Airtanker Base Risk Assessments

Facilities | Hot Loading | Operations | Simultaneous Fueling and Loading

SYSTEM:  Airtanker Base, Hot Loading

Sub-System Hazards Pre-Mitigation Mitigation Post-Mitigation

Probability

Severity

Risk Level

Probability

Severity

Risk Level
Training Not all mixers and loaders are adequately trained and qualified

Possible

Critical

High

 Ensure that all personnel who will be loading aircraft are trained in hot loading procedures, with refresher each year. Provide simulation training for all mixers and loaders (agency and contractor) together throughout the season. Provide adequate briefings for all personnel prior to hot loading any aircraft.

Unlikely

Moderate

Medium

Base not approved for hot loading

Possible

Critical

High

 Ensure base operations plan includes a supplement for hot loading of retardant and is approved at the appropriate level, refer to SABO. Ensure all personnel are trained on hot loading procedures.

Unlikely

Moderate

Medium
Unfamiliar with aircraft to be loaded

Likely

Critical

Extremely High

 Specific type of aircraft will shut down prior to the first load at a new base each year. All personnel involved in the loading of aircraft will receive an orientation briefing for that aircraft to include proper hand signal use, and aircraft loading port valve connection and operation.

Possible

Negligible

Low
Aircraft Dangers of walking into turning propellers, or too close to jet engines

Likely

Catastrophic

Extremely High

 Never walk through a propeller arc, even when engine is shut down. Do not walk under the wing at any time. Operate within the safety area around engines. Only load retardant on the side of the aircraft with non-running engines. Stay behind the wings of SEATs and S2s at all times. FWPT will be posted at front of aircraft where they can see all running engines, loaders, and aircrew.

Unlikely

Critical

Medium
High noise levels working near running engines

Almost Certain

Moderate

High

Only load aircraft on the side opposite running engines. All personnel should wear noise cancelling hearing protection while hot loading retardant. Only essential personnel allowed on the ramp during hot loading operations. Train on proper hand signals to be used during hot loading operations. Take breaks away from noise.

Unlikely

Critical

Medium
Velocity of exhaust/prop wash from running engines (thrust required for breakaway)

Likely

Moderate

High

 Wear approved eye protection. Clear area before pilot takes engine out of ground idle. Ensure no one is behind engines when aircraft starts to move. Ensure Foreign Object Debris (FOD) walks occur on regular basis, so debris is not blown at personnel when aircraft starts moving. Secure loose objects within vicinity.

Unlikely

Negligible

Low
Aircraft can jump chocks while under ground idle

Possible

Critical

High

 Pilot will remain at controls at all times during hot loading operations. FWPT will be positioned at front of aircraft during loading operations and maintain visual communication with both loaders and pilot.

Rare

Moderate

Medium
Heat from running engine(s)

Likely

Critical

High

 Only load aircraft on the side opposite running engines. Only essential personnel on the ramp during hot loading operations. Train on proper hand signals to be used during hot loading operations. Operate within the safety area around engines. Take breaks away from heat.

Unlikely

Moderate

Medium
Human Factors Fatigue of ground personnel

Likely

Critical

Extremely High

 Request additional staffing during times of high fire activity. Take breaks often, stay hydrated, ensure adequate rest facilities are available for all ground personnel. Ensure adequate rest between shifts.

Possible

Moderate

Medium
Heat stress

Likely

Critical

Extremely High

 Utilize additional loaders/FWPTs during high activity. Recognize signs of heat stress at all levels and take action immediately. Stay hydrated, especially prior to beginning shift. Ensure adequate rest between shifts.

Unlikely

Moderate

Medium
Acceptance of high-risk activities as normal

Likely

Catastrophic

Extremely High

 Emphasize importance of situational awareness as a means to recognizing risk. Provide risk management training for all personnel. Ensure thorough briefings/debriefings with special attention to risk management and preventing future accidents. Utilize risk assessments, JHAs, SMS, GARs etc. to assist in mitigating risk.

Unlikely

Catastrophic

High
Distracted personnel (aircrew, loaders, FWPT/RAMP)

Possible

Critical

High

 Focus on task and identified role while hot loading.  Maintain situational awareness at all times. Do not distract others from their assigned task. Ensure communications are occurring at all phases of hot loading; use hand signals.

Unlikely

Critical

Medium

 

Download the word version (docm) of this information to use with the Risk Assessment Worksheet macro.

 

 

Modified / Reviewed:

Print PDF

NWCG Latest Announcements

The Incident Position Standards and Next Generation Position Task Book are now available for Status/Check-In Recorder (SCKN)

Date: August 27, 2024
Contact: Incident Planning Subcommittee 

NWCG is excited to announce that the NWCG Incident Position Standards for Status/Check-In Recorder, PMS 350-32, NWCG Position Task Book for Status/Check-In Recorder (SCKN), PMS 311-32, and Checking In Resources Customer Service Job Aid, J-111 are now available.

The Performance Support Package, which for SCKN includes the Incident Position Standards, Next Generation Position Task Book, and job aid were developed through the Incident Performance and Training Modernization (IPTM) effort. The Performance Support Package will support trainees, those qualified in the position, and evaluators.

References:

NWCG Status/Check-In Recorder Position Page

NWCG Incident Position Standards for Status/Check-In Recorder, PMS 350-32

NWCG Position Task Book for Status/Check-In Recorder (SCKN), PMS 311-32

Checking In Resources Customer Service Job Aid, J-111

The Next Generation Position Task Book and Incident Position Standards are now available for Safety Officer, Field (SOFF)

Date: July 26, 2024
Contact: Risk Management Committee 

NWCG is excited to announce that the NWCG Incident Position Standards for Safety Officer, Field, PMS 350-81 and NWCG Position Task Book for Safety Officer, Field (SOFF), PMS 311-81 are now available.

The Safety Officer, Field (SOFF) is responsible for monitoring operations on an incident from a risk management perspective to provide for the welfare of incident resources and the public. The new Incident Position Standards and Next Generation Position Task Book are developed through the Incident Performance and Training Modernization (IPTM) effort.

References:

NWCG Safety Officer, Field (SOFF) Position

NWCG Incident Position Standards for Safety Officer, Field, PMS 350-81

NWCG Position Task Book for Safety Officer, Field (SOFF), PMS 311-81

Updated NWCG Standards for Electronic Documentation (eDoc), PMS 277

Date: July 25, 2024
Contact: Incident Planning Subcommittee 

The Incident Planning Subcommittee has updated the NWCG Standards for Electronic Documentation (eDoc), PMS 277.

The NWCG Standards for Electronic Documentation (eDoc) establishes the standards for collection and retention of records on wildland fires. This July 2024 update will provide incident management teams the most current standards required to maintain incident records and submit them to host units at the close of an incident.

References:

NWCG Standards for Electronic Documentation (eDoc), PMS 277

eDoc Box Directory (zip file)

NWCG Off-Highway Vehicle Typing Standard Request for Comment

Date: July 24, 2024
Contact: Mobile Fire Equipment Subcommittee 

The Mobile Fire Equipment Subcommittee has released Equipment Bulletin 24-002 NWCG Off-Highway Vehicle (OHV) Typing Standard - Request for Comment. This bulletin outlines the proposed NWCG OHV typing standard, as well as the business need for establishing the standard. Comments on the proposed standard will be accepted through August 15th using the comment form linked below.

References:

ETC-EB-2024-02: NWCG Off-Highway Vehicle (OHV) Typing Standard - Request for Comment

NWCG Off-Highway Vehicle (OHV) Typing Standard Comment Form